![]() The heatbed runs on mains power (in my case 220V) and it’s powered by the integrated Solid State Relay. The power supply is passive, but considering that it only powers the printer hardware and hotend, it’s more than enough. PLA, ABS, Flexible PLA, TPU, Wood, PVA, HIPS Start the printer and heat the nozzle and heatbed (200C for the hotend and 60c for the heatbed should be fine).Īrtillery Sidewinder X1 specs Specificationsģ00 x 300 x 400mm (11.8 x 11.8 x 15.75in).If the belts are not tight, layer shift can appear. Check the belt tension for the X and Y axis.The lead screws need to have a bit of space between the motor shafts, for the couplers to attenuate any movement caused by the lead screws being bent or uneven. I needed to raise the Z rods a bit and then tighten the screws from the couplers. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |